ASTM C917-98
Historical Standard: ASTM C917-98 Standard Test Method for Evaluation of Cement Strength Uniformity From a Single Source
SUPERSEDED (see Active link, below)
ASTM C917
1. Scope
1.1 This test method is intended for use in instances where the purchaser desires information on the strength uniformity of a hydraulic cement produced at a single source. It is intended that this method normally be used for the predominant cement manufactured at a cement plant. Guidelines for sampling, testing, presentation of results, and evaluation are given.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
C150 Specification for Portland Cement
C219 Terminology Relating to Hydraulic Cement
C595 Specification for Blended Hydraulic Cements
C1157 Performance Specification for Hydraulic Cement
E456 Terminology Relating to Quality and Statistics
Keywords
cement; sampling; statistics; strength; uniformity;
ICS Code
ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
DOI: 10.1520/C0917-98
ASTM International is a member of CrossRef.