ASTM C836/C836M-11a
Historical Standard: ASTM C836/C836M-11a Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course
SUPERSEDED (see Active link, below)
ASTM C836 / C836M
1. Scope
1.1 This specification describes the required properties and test methods for a cold liquid-applied elastomeric-type membrane, one- or two-component, for waterproofing building decks and walls subject to hydrostatic pressure in building areas to be occupied by personnel, vehicles, or equipment. This specification applies only to a membrane system that will be covered with a separate wearing course, traffic course, or backfill.
Note 1See Guide C898 and Guide C1471 for proper application of membrane.
1.2 There are no ISO standards similar or equivalent to this ASTM standard.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C717 Terminology of Building Seals and Sealants
C794 Test Method for Adhesion-in-Peel of Elastomeric Joint Sealants
C898 Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with Separate Wearing Course
C1250 Test Method for Nonvolatile Content of Cold Liquid-Applied Elastomeric Waterproofing Membranes
C1305 Test Method for Crack Bridging Ability of Liquid-Applied Waterproofing Membrane
C1375 Guide for Substrates Used in Testing Building Seals and Sealants
C1471 Guide for the Use of High Solids Content Cold Liquid-Applied Elastomeric Waterproofing Membrane on Vertical Surfaces
C1522 Test Method for Extensibility After Heat Aging of Cold Liquid-Applied Elastomeric Waterproofing Membranes
D2240 Test Method for Rubber Property--Durometer Hardness
Keywords
crack bridging; membrane; waterproofing; Weight loss; Thickness; Waterproofing materials/applications; Accelerated aging/testing--elastomeric sealants; Adhesion-in-peel; Building materials/applications--specifications; Crack bridging; Decks--specifications; Elastomeric waterproofing membranes--specifications; Extensibility; Film; Flexibility--roofing/waterproofing materials; Hardness tests; Roofing membranes--specifications; Sealants--specifications; Temperature tests--building materials
ICS Code
ICS Number Code 91.100.50 (Binders. Sealing materials)
DOI: 10.1520/C0836_C0836M-11a
ASTM International is a member of CrossRef.