ASTM C716-06
Historical Standard: ASTM C716-06 Standard Specification for Installing Lock-Strip Gaskets and Infill Glazing Materials
SUPERSEDED (see Active link, below)
ASTM C716
1. Scope
1.1 This specification covers installation procedures for lock-strip gaskets that comply with Specification C 542 and for infill glazing materials in lockstrip gasket glazing applications used in building walls which are not more than 15 from a vertical plane. The prime performance considerations are weathertightness against air and water infiltration, and structural integrity under wind loads.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are provided for information only.
1.3 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C542 Specification for Lock-Strip Gaskets
C717 Terminology of Building Seals and Sealants
C963 Specification for Packaging, Identification, Shipment, and Storage of Lock-Strip Gaskets
C964 Guide for Lock-Strip Gasket Glazing
Keywords
elastomer; gasket; glazing; installation; lock-strip; preformed infill; procedures; Installation--building materials/applications; Lock strip gaskets--specifications; Gaskets--specifications;
ICS Code
ICS Number Code 91.100.50 (Binders. Sealing materials)
DOI: 10.1520/C0716-06
ASTM International is a member of CrossRef.