ASTM C658-98(2003)
Historical Standard: ASTM C658-98(2003) Standard Specification for Chemical-Resistant Resin Grouts for Brick or Tile
SUPERSEDED (see Active link, below)
ASTM C658
1. Scope
1.1 This specification covers the requirements for chemical-resistant resin grouts for filling joints of chemical-resistant brick or tile units. For use of these materials, see Practice C 723. (For mortars, see Specification C 395.)
1.2 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.
Note 1Resin grouts and mortars are differentiated as follows: Resin grouts are applied to the joints, generally 1/4 in. (6 mm) wide, after the brick or tile are set in place and the setting bed has hardened (grouting or tilesetter's method). Resin mortars are trowelled onto the brick or tile in sufficient quantity to achieve a 1/8-in. (3-mm) thick joint after the brick or tile are laid in place (buttering or bricklayer's method).
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C307 Test Method for Tensile Strength of Chemical-Resistant Mortar, Grouts, and Monolithic Surfacings
C308 Test Methods for Working, Initial Setting, and Service Strength Setting Times of Chemical-Resistant Resin Mortars
C395 Specification for Chemical-Resistant Resin Mortars
C413 Test Method for Absorption of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes
C531 Test Method for Linear Shrinkage and Coefficient of Thermal Expansion of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes
C579 Test Methods for Compressive Strength of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes
C723 Practice for Chemical-Resistant Resin Grouts for Brick or Tile
C904 Terminology Relating to Chemical-Resistant Nonmetallic Materials
Keywords
brick; chemical-resistant; grout; tile ;
ICS Code
ICS Number Code 91.100.15 (Mineral materials and products)
DOI: 10.1520/C0658-98R03
ASTM International is a member of CrossRef.