Historical Standard: ASTM C404-03 Standard Specification for Aggregates for Masonry Grout
SUPERSEDED (see Active link, below)
1.1 This specification covers aggregate for use in grout for masonry.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following precautionary cavet pertains only to the test methods portion, Section 8 of the standard. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsiblity of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C33 Specification for Concrete Aggregates
C40 Test Method for Organic Impurities in Fine Aggregates for Concrete
C87 Test Method for Effect of Organic Impurities in Fine Aggregate on Strength of Mortar
C88 Test Method for Soundness of Aggregates by Use of Sodium Sulfate or Magnesium Sulfate
C117 Test Method for Materials Finer than 75-m (No. 200) Sieve in Mineral Aggregates by Washing
C123 Test Method for Lightweight Particles in Aggregate
C127 Test Method for Density, Relative Density (Specific Gravity), and Absorption of Coarse Aggregate
C128 Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate
C136 Test Method for Sieve Analysis of Fine and Coarse Aggregates
C142 Test Method for Clay Lumps and Friable Particles in Aggregates
C144 Specification for Aggregate for Masonry Mortar
C476 Specification for Grout for Masonry
D75 Practice for Sampling Aggregates
aggregate; coarse aggregate; fine aggregate; grout; masonry; sand; soundness