ASTM C323-56(2006)
Historical Standard: ASTM C323-56(2006) Standard Test Methods for Chemical Analysis of Ceramic Whiteware Clays
SUPERSEDED (see Active link, below)
ASTM C323
1. Scope
1.1 These test methods cover the chemical analysis of clays used in the manufacture of ceramic whitewares.
1.2 The analytical procedures appear in the following order:
Note 1These test methods have been compiled as standard procedures for use in referee analyses. These test methods, however, when the determination of iron oxide as Fe 2 O 3 is involved, are not intended to preclude the use of other procedures that give results within the permissible variations. For the sake of uniformity the classical Zimmerman-Reinhardt procedure is specified for the determination of iron oxide. It is recognized that numerous other procedures are equally accurate and often more convenient. The other procedures commonly in use include reduction of an oxidized solution with zinc or other metal, and titration with standard potassium permanganate (KMnO 4 ) or potassium dichromate (K 2 Cr 2 O 7 ) solution, as well as titration with a standard solution of titanous chloride in an oxidized solution. These procedures shall be considered acceptable, provided the analyst has obtained results by his special procedure that check with the Zimmerman-Reinhardt procedure within the limits specified in Section . It is suggested that National Institute of Standards and Technology standard samples be used for checking the accuracy of procedures.
It will be understood that the making of a complete analysis of a ceramic whiteware clay is a difficult procedure requiring a wide knowledge of the chemistry involved in the operations and a thorough training in carrying out the work. A skilled analyst of good training is therefore required to do the work. The descriptions here given cover the vital points of procedure, but frequent reference in regard to the details of the various manipulations should be made to 'Applied Inorganic Analysis' by Hillebrand and Lundell and to similar publications. Particularly in the determination of alumina, reference should be made to Scientific Paper No. 286 of the National Bureau of Standards.
1.3 The values stated in acceptable metric units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C322 Practice for Sampling Ceramic Whiteware Clays
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
Keywords
ceramic whiteware clays; chemical analysis; Alkalies content; Alumina ceramics; Aluminum content; Aluminum oxide (Al 2 O 3 ) content; Ceramic whiteware clays; Chemical analysis; Iron content; Iron oxide content; Lime content; Loss on ignition (LOI); Magnesium oxide (MgO) content; Moisture analysis--ceramic materials/applications; Potassium oxide (K 2 O) content; Silica content; Sodium oxide (Na 2 O) content; Titania; Titanium oxide content;
ICS Code
ICS Number Code 91.100.25 (Terracotta building products)
DOI: 10.1520/C0323-56R06
ASTM International is a member of CrossRef.