ASTM C1312-97
Historical Standard: ASTM C1312-97 Standard Practice for Making and Conditioning Chemical-Resistant Sulfur Polymer Cement Concrete Test Specimens in the Laboratory
SUPERSEDED (see Active link, below)
ASTM C1312
1. Scope
1.1 This practice covers procedures for making and conditioning test specimens of chemical-resistant sulfur polymer cement concrete (SC) in the laboratory. The specimens are cast under accurate control of materials and test conditions using aggregate and sulfur polymer cement (SPC) to make SC that can be consolidated by rodding, as described in this practice.
1.2 Sulfur polymer cement may be furnished as a single or multiple component system.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C470/C470M Specification for Molds for Forming Concrete Test Cylinders Vertically
C904 Terminology Relating to Chemical-Resistant Nonmetallic Materials
National Institute of Standards and Technology
Handbook44: Specifications, Tolerances and Other Technical Requirements for Weighing and Measuring Devices Available from National Institute of Standards and Technology (NIST), 100 Bureau Dr., Stop 1070, Gaithersburg, MD 20899-1070, http://www.nist.gov.Keywords
conditioning; molds; sulfur polymer cement (SPC); sulfur polymer cement concrete or sulfur concrete (SC); test specimens;
ICS Code
ICS Number Code 91.100.30 (Concrete and concrete products)
DOI: 10.1520/C1312-97
ASTM International is a member of CrossRef.