ASTM C1212-98(2004)
Historical Standard: ASTM C1212-98(2004) Standard Practice for Fabricating Ceramic Reference Specimens Containing Seeded Voids
SUPERSEDED (see Active link, below)
ASTM C1212
1. Scope
1.1 This practice describes procedures for fabricating both green and sintered test bars of silicon carbide and silicon nitride containing both internal and surface voids at prescribed locations.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B311 Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity
C373 Test Method for Water Absorption, Bulk Density, Apparent Porosity, and Apparent Specific Gravity of Fired Whiteware Products
Keywords
advanced ceramics; reference specimen; seeded voids; voids; Sintered test bars; Surface voids; Voids; Advanced ceramics; Ceramic materials/applications; Ceramic reference specimens; Fabricated materials; Green test bars; Seeded voids; Silicon carbide; Silicon nitride (Si 3 N 4 );
ICS Code
ICS Number Code 81.060.20 (Ceramic products)
DOI: 10.1520/C1212-98R04
ASTM International is a member of CrossRef.