ASTM C1181-00(2005)
Historical Standard: ASTM C1181-00(2005) Standard Test Methods for Compressive Creep of Chemical-Resistant Polymer Machinery Grouts
SUPERSEDED (see Active link, below)
ASTM C1181
1. Scope
1.1 These test methods cover a quantitative, comparative test for compressive creep of chemical-resistant grouting materials under a sustained load at a test temperature. Constant load is maintained using a bolt and spring washers. Measurements are made at laboratory temperature after exposure periods at the selected test temperature.
1.2 Test Method A outlines the molding techniques for an unbonded test specimen. Test Method B covers the molding techniques for a bonded test specimen.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C904 Terminology Relating to Chemical-Resistant Nonmetallic Materials
Keywords
chemical-resistant; compressive creep; compressive deflection; creep; polymer machinery grouts; stress;
ICS Code
ICS Number Code 83.080.01 (Plastics in general)
DOI: 10.1520/C1181-00R05
ASTM International is a member of CrossRef.