ASTM B695-00
Historical Standard: ASTM B695-00 Standard Specification for Coatings of Zinc Mechanically Deposited on Iron and Steel
SUPERSEDED (see Active link, below)
ASTM B695
1. Scope
1.1 This specification covers the requirements for a coating of zinc mechanically deposited on iron and steel basis metals. The coating is provided in several thicknesses up to and including 107 [mu]m. The seven thickest classes are usually referred to as 'mechanically galvanized.'
1.2 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1-The performance of this coating complies with the requirements of Specification A153 and MIL-C-81562.1.3 The values stated in SI units are to be regarded as the standard. The inch-pound equivalents of SI units may be approximate.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A153/A153M Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware
A194/A194M Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both
A325 Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength
A490 Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength
A563 Specification for Carbon and Alloy Steel Nuts
B117 Practice for Operating Salt Spray (Fog) Apparatus
B183 Practice for Preparation of Low-Carbon Steel for Electroplating
B242 Guide for Preparation of High-Carbon Steel for Electroplating
B322 Guide for Cleaning Metals Prior to Electroplating
B487 Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section
B499 Test Method for Measurement of Coating Thicknesses by the Magnetic Method: Nonmagnetic Coatings on Magnetic Basis Metals
B571 Practice for Qualitative Adhesion Testing of Metallic Coatings
B602 Test Method for Attribute Sampling of Metallic and Inorganic Coatings
B697 Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings
B762 Test Method of Variables Sampling of Metallic and Inorganic Coatings
F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
Military Standard
MIL-C-81562 Coating, Cadmium, Tin Cadmium and Zinc (Mechanically Deposited) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098Keywords
chemical zinc; corrosion resistant coatings; mechanical galvanize; mechanical zinc; zinc coatings; Iron products (general)--mechanically deposited coatings; Mechanically deposited coatings--specifications; Steel--mechanically deposited coatings; Zinc--specifications; Zinc electrodeposited coatings--specifications
ICS Code
ICS Number Code 25.220.40 (Metallic coatings)
DOI: 10.1520/B0695-00
ASTM International is a member of CrossRef.