ASTM A667/A667M-87(2003)
Historical Standard: ASTM A667/A667M-87(2003) Standard Specification for Centrifugally Cast Dual Metal (Gray and White Cast Iron) Cylinders
SUPERSEDED (see Active link, below)
ASTM A667 / A667M
1. Scope
1.1 This specification covers centrifugally cast cylinders with an outer layer of white cast iron and the remainder of the material of gray cast iron. These castings are suitable for pressure containing parts the design strength of which is based on the gray iron portion of the cylinder. These castings are suitable for service at temperatures up to 450F [230C].
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A278/A278M Specification for Gray Iron Castings for Pressure-Containing Parts for Temperatures Up to 650F (350C)
Keywords
centrifugally; design; safety;
ICS Code
ICS Number Code 77.140.80 (Iron and steel castings)
DOI: 10.1520/A0667_A0667M-87R03
ASTM International is a member of CrossRef.